Types of Screen Tabs

Each Application has a master screen, 'Run Manual Session.' The master screen allows you to view all signals live, and select those signals you want the client to view on their screen, on a second monitor.
With our dual display mode, you can connect a second monitor to display a signal screen and a feedback screen at the same time.

The first 4 Tabs on the Screen Selection Toolbar are  found on all applications.
ALWAYS SETUP AN APPLICATION on each TAB, from LEFT-to-RIGHT.
When you start an application, it opens the WELCOME Screen.
The WELCOME SCREEN asks to check impedance.

The Check Signals Screen asks to check signal waveforms.

Next select a protocol on the SELECT PROTOCOL Screen.

Select a Task from the SELECT TASK Screen.
The Task Buttons launch other screens.... Like those shown to the left.

The Screens under these Tabs are used for feedback.
Each Tab is like a folder. Simililar Screens are held underneath a Tab.
For example: all EMG Screens are under one Tab, while all Game/Mosiac-Fill Screens are under another Tab.
Tabs help the user stay within a feedback family. If doinf EMG, and you want to try a different screen, click in the down-arrow and choose an alternative EMG screen without confusing the client about which signal is active for feedback.
Remember that the Task Buttons launch other screens.... Like those shown to the left.

Some Tabs have special functions.
The Quickguide tab is an off-line manual.
About J&J is a screen to contact us.
Occasionally you will find a 'DEMO' screen - these screens are meant for training professionals in audiences. They show how the Control Panel fine-turns the feedback signals - all on one screen for easier comprehension..

SCREENS : PART I:
FOUR-SCREEN APPLICATION SET-UP SEQUENCE:
How to get up and running

SCREENS : PART II:
FEEDBACK SCREENS ON MAIN MONITOR:
Signals Grouped by Tabs

SCREENS : PART III:
FEEDBACK REVIEW SCREENS ON MAIN MONITOR:
Additional Help and Summary and Demo Screens

SCREENS : PART IV:
CLIENT-ONLY FEEDBACK SCREENS ON SECOND MONITOR:
Select by pop-up window, not tabs

Selecting the 'dual Screen' Sidebar Icon pops -up a new window.

Only use these screens if you had previously set up both Physiolab AND USE3 for extended monitor mode.
[ If you do not, and you select ['apply'] a dual screen, it will write on top of your single monitor and corrupt you viewing. You must exit completely and restart.]

SCREENS : PART V:
TABBED SCREENS ARE LINKED TO CLIENT-ONLY FEEDBACK SCREENS ON SECOND MONITOR:
So try to configure in Extended Monitor mode..

Most Feedback Tabs are automatically linked to a dual screen. This allows you the choice of using either one screen or the master-dual screen options 'on the fly'. The key to doing it this way is to pre-configure your computer to run in extended screen dual screen mode.
For those challenged by extended monitor mode, forget about it. These programs work just fine without it.

The top Screen Select Tool bar provides buttons for choosing a specific display screen.  As you learn each application, click on the first tab on the left. follow instructions. Then click on the second tab. Follow instructions. Proceed to the third tab, and follow instructions, etc. The detailed structure is shown below for our simple single EMG application.

PHYSIOLAB APPLICATIONS ARE LOGICALLY ORGANIZED BY SCREENS

DOWN-ARROW shows additional screens...